Photoelectric Smoke Alarm

1) Material: ABS plastic

2) Assembly no wiring, size: Dia.104xH35mm

3) Power supply:9V carbon zinc battery/PP3(battery included)

4) Standby current: 8μA, Alarm current: 16mA

5) Environment temperature: -10°C ~ +50°C

6) Environment humidity: 0 to 95%(40±2°C) 

7) Alarm decibel: louder than 85dB at 10feet(3 meters)

8) Tamper Resist locking pin

9) Test button:To verify the proper functioning of the detector

10)Low voltage warning: Unit beeps every 40 seconds for 30 days (minimum) to indicate a need of battery replacement 

11)Smoke sensitivity:0.086 dB/m to 0.140 dB/m

12)CE, ROHS, EN 14604

13)5 years quality guarantee   

Our factory

TAKING CARE OF YOUR SMOKE DETECTOR

To keep your detector in good working order, you must test the detector weekly, as referring to section "TESTING YOUR SMOKE DETECTOR".

Replace the detector battery when the low battery "beep" signal sounds once a minute. The low battery

"beep" should last at least 30 days.

Open the cover and vacuum the dust off the detector's sensing chamber at least once a year. This can be

done when you open the detector to change the battery. Remove battery before cleaning. To clean detector,

use soft brush attachment to your vacuum. Carefully remove any dust on detector components, especially on

the openings of the sensing chamber. Replace battery after cleaning. Test detector to make sure battery works correctly. Check to make sure there is no obstruction inside the test button. If there is any dust in the test button,insert a toothpick from the back to the front.

NOTE: If nuisance alarms keep coming from the detector, you should check whether the detector's location

is adequate. Refer to section "WHERE TO INSTALL SMOKE DETECTORS." Move your detector if it is not located

properly. Clean detector as described above.

 Clean detector cover when it gets dirty. First open the cover and remove battery. Hand-wash cover with cloth dampened with clean water. Dry it with lint-free cloth. Do not get any water on the detector components. Replace the battery, and close cover. Test detector to make sure that battery works correctly.